Silver Bullet Colloidal Generator Instructions

SILVER BULLET COLLOIDAL GENERATOR

This Silver Bullet Colloidal Generator is powered by 120 volts AC with an output of 56 volts DC and never requires batteries. It produces a primarily ionic silver, but with longer cook times can produce a relatively good particle silver content. Silver ions do not reflect light and therefore do not show color, but particle silver will result in color. This unit works with silver and copper electrodes, but not gold. Note: Copper requires much longer cook times as it is a much harder metal than silver. Following is our Silver Bullet Colloidal Generator Instructions.

Production Instructions:
1. Attach the black generator onto the board matching velcro to velcro and plug the small end of the 120 volt power cord into the generator and the 120 volt AC wall plug end of the power cord into the timer. (Do not plug your unit into your power receptacle until all other steps are complete.)
2. Attach the black and red barrel plugs from the generator to the bare metal of the red and black electrode jacks. (These jacks are your 48 or 56 volt DC output. One is positive and the other is negative.)
3. Now you can set your timer to the desired cooking and cooling times. This will also extend the life of your generator and electrodes in case you forget to turn the generator off.

Timer Setting (A-E): The timer has two positions selected by a slide switch on top of the timer; Outlet On and Timer On.
A. Slide the grey switch on the top side of the timer to “Timer On”.
B. Looking at the dial, pull all the grey switches out from the face of the dial.
C. Set the “Time Now” arrow to the nearest ½ hour on the appropriate Day or Night scale and push down the two grey switches immediately after your time setting. Each switch represents ½ hour increments, so two depressed switches will give you 1 hour of ‘cooking time”. It doesn’t matter if the actual day/night time is not perfectly accurate.
D. Leave the next switch past the two depressed ones in an out position, giving ½ hour of cool down/off time. To ensure that the two electrodes both wear down somewhat uniformly simply switch the red and the black electrode clips. You may also wipe the residue from the electrodes if you want less silver oxide in your product, but it isn’t harmful or necessary.)
E. If you want a stronger product with more particles, simply repeat the cycle settings around the dial as you desire. (Particles will be evidenced by color; the more color, the more particle content.)

Now Continue…..
4. Fill the 1 quart glass jar to the top of the shoulder (or about 1” below the underside of the generator board) with distilled water. Test the distilled water PPM reading with the TDS-1 tester to be sure it is at 1 PPM or less.
5. Next insert the two electrodes into the holes on the white mounting board allowing the red and black electrode jacks to support the electrodes and place the unit onto the glass jar with the electrodes in the water. (Do not allow the electrodes to touch each other after the unit is plugged in as it may short out and damage the generator.)
6. Last, plug the timer into a 120 volt wall outlet and the timer will start automatically.

Note: Ionic content will register on the TDS-1 meter, but particle content will not. Particle content will be evidenced by its color since particles reflect light and ions do not. This DC process makes a primarily ionic product with a good dispersal of silver particles with repeated cook times. More info on ionic silver vs. particle silver, go to the FAQ section.

Note: This 120 volt AC to 48 or 56 volt DC generator makes a primarily ionic product and ionic content will register on the TDS EZ meter, but particle content will not. Particle content will be evidenced by its color since particles reflect light and ions do not. For more info about ionic silver vs. particle silver, visit the FAQ page.

50% Discount Offer: Although this home generator can produce a reasonably effective silver product, if you sometimes require a more therapeutic internal use, it may be necessary to use a higher particle silver such as our Advanced Colloidal Silver. If you have purchased any of our home units, but occasionally want to use our Advanced Colloidal Silver, it will be made available to you at anytime with a buy one 8 oz. bottle or a one gallon jug at the regular retail price and get one free. This amounts to a 50% discount. Simply call in and give your name and original generator order number to the order desk clerk to find your original order in the database. This offer is available by call in only at 830 966-2315. Limit: 3 free 8 oz. bottles and one free gallon jug per month per household. (We accept no responsibility for misuse of this product.)

If you require a more therapeutic internal use, it may be necessary to use a higher particle silver such as our Advanced Colloidal Silver. If you have purchased any of our home units, but occasionally want to use our Advanced Colloidal Silver it will be made available to you at anytime with a buy one 8 oz. bottle or a one gallon jug at the regular retail price and get one free. Simply call in and give your name and original generator order number to the order desk clerk to find your original order in the database. This offer is available by call in only at 830 966-2315. Limit: 3 free 8 oz. bottles and one free gallon jug per month per household.

Share